Author Topic: Brembo rear master cylinder pushing rod problem  (Read 452 times)

hellblom

  • Newbie
  • *
  • Posts: 30
Brembo rear master cylinder pushing rod problem
« on: March 28, 2020, 06:06:50 am »
Hi all,

perhaps a few of you have replaced the stock rear master cylinder with a Brembo one. I did the other day but can't figure out how the pushing rod should stay positioned without falling out of the cylinder. The only way it works for me currently is if I have the brake pedal rest one the motor cover, which is causing it to scratch it and whatnot.

So any tips here?

Regards,
Olle

hellblom

  • Newbie
  • *
  • Posts: 30
Re: Brembo rear master cylinder pushing rod problem
« Reply #1 on: April 01, 2020, 03:24:19 pm »
I will answer my own question. I did fit a washer to keep the push rod attached.