Ascot Forum
First Generation Ascots => Tech Section => Topic started by: Cidde on May 17, 2016, 04:44:27 pm
-
Hi
My float messed up so I took apart and cleaned my carburetor and now it will not start. What could I have done wrong?
-
Hard to say without seeing what you have in front of you.
Are you sure that the float is moving up & down freely? If the float is stuck in the upward position, it will not allow any fuel into the bowl.
J.
-
The cycle starts with the start gas.
Choke slide back to its original position.
I´ll get back when I've screwed it apart again.
-
The fuel petcock is vacuum controlled. After you empty the carb, you have to crank the engine for a while to allow enough fuel to fill the bowl.
You might consider performing this modification: http://ascot500.com/index.php?topic=256.msg1070#msg1070
Make sure that you read & understand the warning that is included in that information.
J.