First Generation Ascots > Tech Section

Third gear noice

<< < (4/8) > >>

Chronic:
...And XL gearbox, i have a set like this, the question is, if this gonna fit?

Chronic:
I now have both engines cracked open, the XR gearbox lookes the same as FT's

I also noticed that a kickstarter conversion is not that hard, if u want. Of course u gona need an axel and a engine cover, But it all fits in the engine

WTF304:
Actually you don't need the engine cover .... you need the kick shaft seal and the kick shaft and associated gears ... washers .... spacers etc. The clutch cover is exactly the same there is an aluminum plug and rubber seal. It pop's right out ..... look for my post XL/XR kickstarter i have a picture there

Chronic:
Yeah you are right, its just a plug in the cover.

Chronic:
So now the gears are in place...

Just to be sure, is there anyone who knows how to realign the markings to set the Counter balancer?

Also, on the mainshaft sprocket that drives the CB there's a quite big offset weight, should that also be in any paticular direction?

Is there a workshop manual to be downloaded from somewhere?

Navigation

[0] Message Index

[#] Next page

[*] Previous page