First Generation Ascots > Tech Section
XR's Only - High Performance Parts For The XR500 & The FT.
(1/1)
J6G1Z:
I just talked with "Tech" at XR's Only & they offer many high performance parts that will cross-over to the FT500.
Here is a portion of the XR500 parts available.
http://www.xrsonly.com/dirt-bike-parts/honda-dirt-bike-parts/honda-xr500r
Thanks
J.
thumperdh:
Would you happen to know if those IMS Foot pegs for the XR500 would cross over to the FT frame?
J6G1Z:
--- Quote from: thumperdh on October 17, 2013, 09:14:09 pm ---Would you happen to know if those IMS Foot pegs for the XR500 would cross over to the FT frame?
--- End quote ---
I don't know. They look like they might, but the FT has a rubber mounted foot-peg mount & I highly doubt that the XR has the same. I modified my FT pegs by taking the peg apart & getting down to the tube that is inside the rubber cover. I then cut the tube to where it was just a stub long enough to fit the foot-peg mount & hinge up & down. I bought a pair of used KTM dirt bike pegs off of eBay & had them welded to the stubs. Here is my posting on my pegs: http://ascot500.com/index.php?topic=79.msg308#msg308
Those IMS pegs look nice, but you can fab up something that is close for a lot less than $100
Good luck
J.
Navigation
[0] Message Index
Go to full version