First Generation Ascots > Tech Section

82 CB250rs pinion

<< < (2/2)

scottly:

--- Quote from: wrk2ride_ride2wrk on July 16, 2014, 06:50:42 am ---
There's a partial gasket set available here, which is minus the clutch cover gasket.
Would the 82 XL500 clutch cover gasket fit?



--- End quote ---
I checked the part numbers for the "right crankcase cover gasket", and they don't match. However, I looked at my '82 XR 500 motor, which uses the same gasket as the XL 500, as well as some XL/XR 250s, and I can't see any external difference in the cover of my FT? I would bet a cyber-beer the XL/XR gasket would work. ;D

wrk2ride_ride2wrk:
"I checked the part numbers for the "right crankcase cover gasket", and they don't match. However, I looked at my '82 XR 500 motor, which uses the same gasket as the XL 500, as well as some XL/XR 250s, and I can't see any external difference in the cover of my FT? I would bet a cyber-beer the XL/XR gasket would work."

Cheers, I owe you beer  ;D, put together a set for $32 total with the XL250s gasket.

Blasting the barrels & head / paint today, so looking forward to starting this bad boy sometime next week.

Many thanks

Navigation

[0] Message Index

[*] Previous page