First Generation Ascots > Tech Section

Brembo rear master cylinder pushing rod problem

(1/1)

hellblom:
Hi all,

perhaps a few of you have replaced the stock rear master cylinder with a Brembo one. I did the other day but can't figure out how the pushing rod should stay positioned without falling out of the cylinder. The only way it works for me currently is if I have the brake pedal rest one the motor cover, which is causing it to scratch it and whatnot.

So any tips here?

Regards,
Olle

hellblom:
I will answer my own question. I did fit a washer to keep the push rod attached.

Navigation

[0] Message Index